Difference between revisions of "Hardware: Sensor Wiring"
(→Load Cells) |
|||
| Line 10: | Line 10: | ||
[[File:Loadcell connector 2.jpg|thumb|right|500px]] | [[File:Loadcell connector 2.jpg|thumb|right|500px]] | ||
[[File:Loadcell connector 3.jpg|thumb|right|500px]] | [[File:Loadcell connector 3.jpg|thumb|right|500px]] | ||
| + | |||
| + | #Remove any heatshrink from the load cell cable. | ||
| + | #Cut off the drain wire. | ||
| + | #Spread out the four wires and arrange in the following order" | ||
| + | Red, White, Green, Black. | ||
| + | |||
<br clear=all> | <br clear=all> | ||
Revision as of 03:17, 4 December 2015
The Developers Kit uses RJ14 (6p4c) connectors for most of the sensors. The Registered Jack (RJ) series connectors install using an inexpensive crimping tool.
Load Cells
- Remove any heatshrink from the load cell cable.
- Cut off the drain wire.
- Spread out the four wires and arrange in the following order"
Red, White, Green, Black.
DHT22 Temperature and Humidity Sensor
