Difference between revisions of "Sensors: BME680"
| Line 10: | Line 10: | ||
gcc bme680_main.c bme680.c -o bme680 | gcc bme680_main.c bme680.c -o bme680 | ||
| + | |||
| + | ===Wiring Adafruit=== | ||
| + | |||
| + | Note that this pin out is only for the Hive Interface boards ver 1.0. The wiring will be slightly different for the ver 0.3 boards and earlier. | ||
| + | |||
| + | {| class="wikitable" | ||
| + | ! scope="row" colspan="2"| H2 I2C Bus ver 1.0 | ||
| + | ! scope="row" colspan="1"| Adafruit break out board | ||
| + | |- | ||
| + | ! scope="col"| Pin | ||
| + | ! scope="col"| Signal | ||
| + | ! scope="col"| BME680 | ||
| + | |- | ||
| + | | 1 | ||
| + | | +3.3 | ||
| + | |VIN | ||
| + | |- | ||
| + | | 2 | ||
| + | | I2C | ||
| + | | SDI | ||
| + | |- | ||
| + | | 3 | ||
| + | | I2C | ||
| + | | SCK | ||
| + | |- | ||
| + | | 4 | ||
| + | | NC | ||
| + | | | ||
| + | |- | ||
| + | | 5 | ||
| + | | Ground | ||
| + | | GND | ||
| + | |} | ||
| + | |||
===Test=== | ===Test=== | ||
Revision as of 04:49, 5 July 2018
BME680
Download the drivers
git clone https://github.com/BoschSensortec/BME680_driver.git git clone https://github.com/twartzek/bme680-raspberry.git
Compile
gcc bme680_main.c bme680.c -o bme680
Wiring Adafruit
Note that this pin out is only for the Hive Interface boards ver 1.0. The wiring will be slightly different for the ver 0.3 boards and earlier.
| H2 I2C Bus ver 1.0 | Adafruit break out board | |
|---|---|---|
| Pin | Signal | BME680 |
| 1 | +3.3 | VIN |
| 2 | I2C | SDI |
| 3 | I2C | SCK |
| 4 | NC | |
| 5 | Ground | GND |
Test
./bme680 **** BME680 start measurements **** 2018-07-05 13:27:40 T: 25.14 degC, P: 942.12 hPa, H: 74.29 %rH, G: 8029 Ohms 2018-07-05 13:27:43 T: 25.13 degC, P: 942.12 hPa, H: 74.29 %rH, G: 9043 Ohms 2018-07-05 13:27:46 T: 25.11 degC, P: 942.10 hPa, H: 74.38 %rH, G: 9976 Ohms **** Measurement finished ****
