Hardware: PCB Assembly

Parts

Parts List

Mechanical Drawing for RJ connectors.

Assembly

1.Insert the 2x20 female header from the bottom side of the board.

• Error creating thumbnail: File missing

  1.1 Insert the header from the bottom.

• Error creating thumbnail: File missing

  1.2 Solder one pin on each end.

• Error creating thumbnail: File missing

  1.3 Check the connector for alignment.

• Error creating thumbnail: File missing

  1.4 Melt solder and straighten.

2. Solder the header on the top (component, silk screen) side of the board.

• Error creating thumbnail: File missing

  2.1 Solder the rest of the pins.

3. Install the following resistors:

1. R1 330
2. R2 200K
3. R3 1K
4. R4 2.2K
5. R5 2.2K
6. R6 1K

• Error creating thumbnail: File missing

  1.1 Insert the resistors.

4. Install male headers

1. H8 1x4 and H9 1x6 for the HX711 board.
2. H4 1x4 for console serial port

• 

  1.2

1. Install RJ1 and RJ2. Be very careful to check that all the leads are in the holes before you snap it in place.

1. Insert the 1x4 and 1x6 female headers on the make headers.
2. Install the HX711 board on the 1x4 and 1x6 female headers.
3. Install LED D1.
4. Install C1 4.7 mfd. Observe polarity.
5. Install C3 .1 mfd. for rain gauge filter.
6. Install 12 VDC power supply if used. See below for option 1 or 2.

Power Supply 1

1. Install four 1x2 male headers.
2. Install blue screw terminal block.
3. Install four 1x2 female headers on the four 1x2 male headers.
4. Install the Power Supply board on the four 1x2 female headers.

power Supply 2

1. Install Fulree voltage regulator
2. Install green spring terminal block.