Hardware: Sensor Wiring

From HiveTool
Revision as of 03:17, 4 December 2015 by Paul (talk | contribs) (→‎Load Cells)
Jump to: navigation, search

The Developers Kit uses RJ14 (6p4c) connectors for most of the sensors. The Registered Jack (RJ) series connectors install using an inexpensive crimping tool.


Load Cells

Loadcell connector 1.jpg
Loadcell connector 2.jpg
Loadcell connector 3.jpg
  1. Remove any heatshrink from the load cell cable.
  2. Cut off the drain wire.
  3. Spread out the four wires and arrange in the following order"

Red, White, Green, Black.



DHT22 Temperature and Humidity Sensor



TSL2591 Lux Sensor

Retrieved from "http://wiki.hivetool.net/index.php?title=Hardware:_Sensor_Wiring&oldid=2075"